PocketWizard N10-ACC-D200 3' Remote Camera Cable

For remotely triggering the electronic shutter release of Nikon cameras with a Nikon 10 Pin Remote Terminal.

This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the N90M3

• For Nikon 10-Pin Terminal (ex. D100/200)
• For all PocketWizard Radio Triggers
• Remote On/Off: Plus III, Later MultiMAX
• Remote On/Off with FleXTT5 as Receiver
• Add PTMM Adapter to Make Pre-trigger
• Includes MSMM Adapter
• Use with Plus, Plus II, Early MultiMAX

• Cable length: 3' (91.5 cm)

For MultiMAX with ACC port. This cable will NOT work with the Plus II. Works with the Nikon D200 or D100 with MB-D100 but will not work with the D700. Use the N90M-ACC-ND cable for that camera.

ACC Cables are a special kind of Pre-Trigger cable for use with the new FleXTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FleXTT5 if using E-TTL functions.

NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an ACC cable with a FleXTT5 but you will not have E-TTL capability.

Compatible with cameras using Nikon 10-pin Remote Terminal including:
Nikon
• N90
• N90S
• F5
• F6
• F100
• D1
• D1x
• D1H
• D2x
Nikon
• D2xs
• D2H
• D2Hs
• D3
• D700
• D300
• D200
• D100 w/ MB-D100
Fuji
• S3 Pro
• S3 Pro UVIR
• IS Pro
Kodak
• DCS Pro SLR/n
• DCS Pro 14n
• DCS 760
• DCS 720x S5 Pro
• DCS 660
• DCS 660M
• DCS 620
• DCS 620x