PocketWizard N90M3ACCND Nikon 10 Pin Remote Pre-Trigger Cable (Including D700) for MultiMax / FlexTT5

About this item

For remotely triggering the electronic shutter release of Canon cameras with a Nikon 10 Pin Remote Terminal.

This cable contains a pre-trigger switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the N90M3


• Cable length: 3' (91.5 cm)

• From Nikon 10-pin Remote Terminal

• To Pre-trigger Switch

• To 1/8" (3.5 mm) Steroe Miniphone

For MultiMAX with ACC port. This cable will NOT work with the Plus II. Works with the Nikon D700 but will not work with the D200 or D100 w/MBD100 . Use theN90M-ACC cable for those cameras.

-ACC Cables are a special kind of Pre-Trigger cable for use with the new FlexTT5 or the latest MultiMAX. Toggle Pre-Trigger on and off remotely with the MultiMAX. Required for remote camera triggering with a FlexTT5 if using E-TTL functions.

NOTE: An older mono motor drive cable and/or pre-release cable can be used instead of an -ACC cable with a FlexTT5 but you will not have E-TTL capability.

Compatible with cameras using Nikon 10-pin Remote Terminal including:
Nikon

• N90

• N90S

• F5

• F6

• F100

• D1

• D1X

• D1H

• D2X
Nikon

• D2Xs

• D2H

• D2Hs

• D3

• D700

• D300

• D700
Fuji

• S3 Pro

• S3 Pro UVIR

• IS Pro
Kodak

• DCS Pro SLR/n

• DCS Pro 14n

• DCS 760

• DCS 720x S5 Pro

• DCS 660

• DCS 660M

• DCS 620

• DCS 620x