Cut foamboard V-grooves to perfection using the FoamWerks Foamboard V-Groove Cutter. Features include adjustable blade depth, quick change blade clips, magnetic blade slot, on-board blade storage drawer and five blades. Use with FoamWerks Channel Rail W-3001, Logan Adapt-A-Rule or Team System. Works with any depth foamboard. Note: At some settings, the V-Groove Cutter may cut completely through the foamboard. If this is NOT the effect you desire, be sure to do a test cut prior to your final cut. Note that the V-Groove Cutter cannot cut completely through 1/2 foamboard (1.27cm). Use replacement blades WC-10, WC-25 or WC-100.
Reviewed by 2 customers
As a model railroader, I am always looking for cheaper, stronger, and easier to use alternatives to the normal materials of wood and plastic. Foamboard not only meets those criteria, but it is also more lightweight. After buying some inexpensive sheets of foamboard, and chopping them up into little useless bits, I decided to look for a better way to cut and shape the foam. After pouring over Youtube videos, I found the FoamWerks equipment offered by Adorama.
Foamwerks foamboard V-groove cutter is a huge disappointment. The unit cuts unevenly. Because the resulting groove is asymmetric it is impossible to get a an accurate and solid 90 degree angle on the foamboard. On closer inspection it appeared that the unit might be factory defective. I contacted customer service at Logan Graphics and at their instruction sent the unit to them - their response has been customer nonservice. Nearly two months and ten emails later I have yet to receive a replacement unit.