Tiffen Combination 85 IR and 1.2 Neutral Density (ND) Filter - What do you do when you must take some photos outdoors and all you have left is tungsten film? Using tungsten film in daylight will produce a bluish cast in the photograph. The 85 series of filters will "bring back", i.e. color balance the tones in your images. These yellow filters are used to correct differences in color temperature between the recording medium (film/video) and the light source.
Color shift is a critical factor in digital photography. This color shift is directly affected by the infrared spectrum. Specifically, in high definition photography, the sensitivity of imaging sensors to IR has become a challenge. This is particularly evident when using standard neutral density filters that absorb visible light but pass infrared. Unlike many photographic films, the CCD or CMOS of a digital camera is inherently susceptible to infrared contamination, even when the manufacturer attempts to reduce this problem by adding an infrared absorbing filter on top of the image sensor.
Because this filter do not have a sharp cutoff at the infrared wavelengths there has to be a compromise in order not to exclude visible red wavelengths. This results in some infrared wavelengths being allowed to pass. While minor infrared contamination does not normally cause much of a problem for visible images, when using conventional neutral density filters especially denser grades, this issue is multiplied by the filter factor.
|Filter type||Combination 85/ND|
|Filter Factor||ND: Reduces ISO to 1/16
85: 1.8 (+2/3 stop)
|Effect||ND: Reduce the amount of light reaching the film
85: Removes excessive blue from images and produces more natural colors
|Application||ND: To use high speed films in bright sun
85: When pleasing color balance is desired when shooting with tungsten film outdoors
|Color Temperature||ND: No change
85: Decreases the color temperature from 5500-3400 Kelvin
|Size||4 x 5.65" (100 x 140mm, 4mm thick)|