Crimson Trace LaserGuard Red Laser Sight for Springfield Armory XD & XD(M) Pistols

2018-04-11T14:46:40

I like it so far. It was pretty easy to install and adjust. I just have to decide the distance i want to site it at.

Marcus M.

2015-12-14T19:00:00

Because this laser does not utilize the rail, it will shift side to side when I take it in and out of my holster. This makes the laser useless. It is a shame that I have to go through the hassle of reselling it, now.

Jordon

2015-08-27T20:00:00

Quick install and a perfect fit. Front end flush with slide and barrel. Clamps around trigger guard and uses one notch of the rail but does not actually clamp to the rail. Very secure.

Bob

2015-03-27T20:00:00

Bought my Springfield XD .40 from a local retailer. Gun came already equipped with the crimson trace red laser. They made the laser fit perfect with the guns ergonomics. Feels like it is a factory piece. After easily adjusting the laser to my liking it is dead on and have even been able to hit a 4" circle target from 30' holding the gun sideways and, you know, "throwing the bullets" like a real OG. I bought the gun for home protection and for target shooting. Laser does its job and I couldn't be happier with the Springfield/Crimson Trace combo.

hot

2014-11-26T19:00:00

Love it except that it will move side to side a little bit. I can't push it one way or the other a little with my finger and the dot will move out of alignment with the Iron sights. Also does it from being in the holster on my side. The screws are plenty tight. Its on an xd .40 sub compact.

kev

2014-01-09T19:00:00

top of the line

bddfc

2013-09-23T20:00:00

I have XDM 9mm and read all about Crimson Trace. Purchased the Laserguard 446 and have loved it since day one. I don't ever have to remember to turn it on, because just a normal grip on my gun will turn it on. It is one less thing I need to remember if I need to use in a high pressure situation. I bought a second pistol almost a year later and did not think twice about buying a Crimson Trace Laser for that one too. Once they were zeroed in, they stayed on target and had great battery life. I had a operational problem on one of the Lasers, but Customer service replaced the unit without delay. I was up and running again in almost no time. I would highly recommend this laser to all.

ex-capt444

2013-03-01T19:00:00

I bought a LG-448 for my XD, I installed it and It did not work. I tried differnt batteries and still it did not work. I have tried to contact Crimson trace over e-mails and the website, and still have not heard back from them.

Chris

2013-02-28T19:00:00

Product was very easy to install. It fits the 9mm 5.25" Competitor Series gun great. Looks and operates as expected, thankfully.

John

2012-11-21T19:00:00

After buying a set of grips for my Colt Defender and falling in love, I went out to buy a set for my wife's XD subcompact. After looking at those grips, I went with the laserguard, instead. I'll admit, I'm a cheap bastard, so saving money was great, as well. I was worried that there might be a difference between using grips and the laserguard, but they use the same theory of the button switch in front of the grip. Works great. With a barrel as short as the sub has, I was worried that it might be best used for a close contact situation. But with the help of the laser, I was getting impressive groups at 25 yards in the pumpkins I was persecuting. How impressive? I drew a set of eyes on the gourd with magic marker (I figure it was like having two small targets to shoot at). I was able to keep all rounds inside the eyes, right out of the box. This laser thing is great! If you're like me, and held off buying lasers in fear of becoming lazy, don't. These lasers-both for the Colt and the XD are the best mods I can do to the pistols, in my opinion. I'll add a set to each gun I use for defense from now on...

Michiel

2012-04-02T20:00:00

After getting a Crimson Trace LaserGuard for my LCP I just had to have one for my XD-9 SubCompact. I was concerned about the fit because of the short barrel so I called crimson trace and was assured it would fit. It fit perfectly and just as easily as the CT laser on my LCP. Wow! I could not be happier. My friend watched me shoot out the center of my target and said " you could probably write your name with bullet holes". So I took out the ring numbers on the target. He had me buy a CT laser for his KelTec and now he's very happy too.

Ray

2012-01-17T19:00:00

I recieved this laser sight as a gift from my uncle when I purchased my xd subcompact .40. Upon taking it out of the box i was excited. The laser looks great and feels great! It snapped right on to my xd and 3 small screws and 10 min later it was snug tight!! It works really well. The only thing I do not like about using the laser, has nothing to do with Crimson Trace, but that there are only a few holsters that will hold the xd with this laser installed. I love my blackhawk concealed carry holster and hate to give it up to use my laser. I wish blackhawk would make an accomodating holster.

Trigger

2011-12-17T19:00:00

Had tried a competitive product that mounts on the rear sights, and took it off (want to buy it from me cheap? lol). Purchased this and could not have been more pleased. Installed very easy (surprizingly actually). So far, factory aim set at 50' worked as advertised. Had to get a new holster, of course, but got that as well and am extremely happy. Managed to talk my wife into one for my Sig P238 for Christmas!

PaulW

2011-12-10T19:00:00

Easy installation, Great feel, increased my accuracy. I've even plucked a couple of varmits (Oppossum and Raccoon) from under my bird feeder with it. Loved my XD(M) before - with the LG-448 - Love it even more.

bobbert

2011-12-03T19:00:00

Where to start? Design: just brilliant! The placement under the trigger guard enables truly instinctive control of the light. Slight natural grip pressure using the middle finger, paints the target only when needed to make a shot. The original gun thickness is preserved. Installation: 10 minutes from a sealed box to checking sight alignment! Reliability: Mine spent a day in my dogs water bowl in the car! (Don't ask!). A quick wipe, dry with heater vents in the car, and it worked like new! I've fired about 300 rounds with this sight, and no adjustments have been necessary. I carry concealed daily, and the sight is always mounted on the gun (XD(m) 3.8 compact 40). I did have to get a new holster that could accommodate the new shape caused by the laser. Dragon made one that works perfectly. It is both an IWB/OWB tuckable rig. I also got a vehicle holster. My Crimson Trace goes everywhere!

cia1984

2011-11-11T19:00:00

Installed in minutes on my XD40SC. Actually like it better than the Lasergrips model because I can keep my grip thin. Nice job Crimson Trace.....another sweet product.

creepyguy