
This item is no longer available.
Review Summary
2023-07-29T20:00:00
Great design for mounting bipod or fore grip device on rifle. Just like all other 1 star reviews. Mine has the same problem, the pin that is holding swivel stud fell out on a range trip and I could not find it anywhere.
XLI9
2023-06-25T20:00:00
I purchased this item for two purposes 1) bipod attachment 2) attached a light. I have just just tried attaching it to my rifle (a Sako). The website say " By adjusting the tension on the front and rear T20 screws you can change the vertical angle of the Pic Rail Adapter to align with the barrel instead of the stock" This should be followed by a disclaimer?."Maybe has sufficient adjustment to align" I discover there is insufficient adjustment in the screws to allow for the rail to align with the barrel, it is out by a significant margin. I would advise that you (somehow) check the angle of the stock and the items adjustment capability BEFORE you buy. Of course if you just want it to attached a bipod then it is fine. Significant buyer regret?.unimpressed Caldwell!
Gazza
2023-02-08T19:00:00
Bought this to put an IR light on my bolt gun. It works perfect!
Marcus S.
2023-01-03T19:00:00
Need a sling mount to mount this product to. Didn't know I needed extra parts to mount the product.
Laeljon
2022-11-08T19:00:00
Really love this. Turns the sling stud into a picatinny rail AND you get to keep a sling stud. I have one of these on all of my rifles. Note: On some synthetic stocks, you may need to shave down any over sized studs to fit. It's no bother at all.
Bullets B.
2022-02-28T19:00:00
Six months old. Took my gun out of the case today, and the swivel guide pin had slipped out; my sling was now disconnected at one end. Just imagine....I'm carrying the rifle with sling, the pin slides out, and the end of the barrel slams into a large rock.
Greg24
2021-12-17T19:00:00
I'm hunting hogs out of a box blind with a window that is 10" tall. Using the Hog Sniper light I have mounted on top of my Zeiss scope on my 300 Win Mag Shillen Rifle won't work. The Caldwell Pic Rail allowed me to mount the light under the barrel and have the light outside the box blind. Worked Great
Jack R.
2021-12-08T19:00:00
The adapter fit without much trouble. I attached a Sniper hog light to that adaptor plate and could see like I have never been able to see a target before.. I need another one for another Rifle they are really good!
Jack R.
2021-12-08T19:00:00
I've had this pic rail for three months and the sling stud pin either broke or fell out in the field and metal contacts stock and causes wear.
Bilbo349
2021-10-09T20:00:00
The very first time I installed the pin fell out that holds the sling base to the pic rail.
Bigbear
2020-07-10T20:00:00
The design, concept, materials & installation were excellent EXCEPT the company might consider including 2 or 3 different diameter cross pins In the package AND bevel at least one end of each. My Marlin 22WMR Bolton action with laminate stock came with the factory installed sling stud a bit too low and slightly askew. To get the pin to work I had to back the stud a full turn out but then the stud was too loose. Didn’t want to strip out of the stock. Was able to get by with 1/2 turn but had to use a 6d finish nail cut to the right length instead of the supplied pin. I appreciate the rubber base gasket, wide and thick enough to protect the nice factory finish on the stock. Have already ordered more for other projects.
Shimsham
2020-04-24T20:00:00
I purchased this product several months ago and I have been very satisfied with it's fit, form, and function. Very simple installation, less than 15 minutes to read the instructions, mount it on the stock and done. I will very soon purchase two additional of these to mount on other rifles that I have. For the money, you can't beat it!
RJ44
2020-02-29T19:00:00
Due to it being on the sling swivel, the only real way to get it straight is to get it tight. In my case I could not utilize the rubber spacer it came with it was to lose and would wobble from side to side. So, don’t screw out the swing swivel to much. Also take the set pin they sent with it and bevel one end so it will go through both sides easier. What should have been a five-minute project took about an hour. But I am happy with the end results. Hope this helps.
ThunderBunny
Accidents happen. Protect your favorite Adorama products and purchase a protection plan to stay covered from accidental damage, mechanical or electrical failures, and more.
If we can’t fix it, we’ll replace it at no additional cost.
Protect your product from drops, spills, and more.
Enjoy your gear without fear. We have you covered!
When regular use of your product over time results in mechanical or electrical failure.
We will never charge you a deductible after the purchase of a plan.
Our claims process is simple & easy and our customer service team is happy to help.
Adorama Protect powered by Extend is available for purchase to customers in the United States. Not available for international or U.S. territories purchases. Plans on open box items do not cover pre-existing damage.
Adorama Protect plans are available for ABS clients. If you have any questions or require assistanse, please call 800-223-2500
Browse our FAQ
Black
Aluminum, Steel
661120567165
Awesome Product
By Marcus S.
Bought this to put an IR light on my bolt gun. It works perfect!
Brilliant. Best of both worlds.
By Bullets B.
Really love this. Turns the sling stud into a picatinny rail AND you get to keep a sling stud. I have one of these on all of my rifles. Note: On some synthetic stocks, you may need to shave down any over sized studs to fit. It's no bother at all.
The Caldwell Pic Rail Adapter is perfect for utilizing both your shoulder sling and a pic rail mounted accessory at the same time. By adjusting the tension on the front and rear T20 screws you can change the vertical angle of the Pic Rail Adapter to align with the barrel instead of the stock.