DigitalFoto Solution Limited ARES Z-Axis Spring Dual Handle for Gimbals

If your gimbal handle diameter is smaller than 40mm, like 31mm Zhiyun Crane Plus&Crane V2,then you need to insert our round base plate into Ares middle connect bridge clamp,tighten it,and then install gimbal on top of the round base plate via 1/4" screw.

World first Z axis alloy spring dual handle for Ronin S,also compatible with any 40-46mm handle including FEIYU/ZHIYUN/DJl/MOZA Single handle gimbal

• 30% reduce vertical vibration
• One tighten knob to tight gimbal, Save time!

Why Choose DF DIGITALFOTO ARES Z Axis Spring Dual Handle?

• One tighten knob to tight gimbal
• With anti-scratch rubber mat, your gimbal handle will be protected
• Compatible with 40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu Series Gimbal
• With Spring arm design, effectively 30% reduce vertical bounce
• 1/4 threaded hole on handle top for installing LED/Microphone/Monitor etc
• Handle is connected to the arm by anti-slip gear, which avoid handle moving especially for using Ronin S
• Weight Bear 1.8-Skg,can meet most gimbal with camera+others
• Adjust arm tension to achieve best condition for your balance and shooting
• Anti-slip rubber handhold
• By changing handhold direction, you can achieve inverted shooting
• Detachable design, which make it portable
• Small raised nails ensure the arms will not fall down
• Net weight Ikg,ensure not add too much weight for two hand

NOTE:Rotate the knob clockwise will increase the tension of the arm; turn the knob counterclockwisel will reduce the tension of the arm

• Net weight 1kg, ensure not add too much weight for two hand.
• Weight Bear 1.8-5kg, can meet most gimbal with camera+others
• Compatible with 40-46mm handle like Ronin S/ Zhiyun Crane 2/Crane V2/Crane Plus/Feiyu/ Moza Air 2 Series Gimbal

To make your Crane 2 & Ronin S shooting more comfortable, you can order DIGITALFOTO Spider Mounting Ring with Strap to release your handle.