DigitalFoto Solution Limited Car Suction Cup with Safety Strap and Vibration Isolator for Camera/Gimbal

- Car Suction Cup with Safety Strap -
30-50cm extendable flexible legs and ball joint design can help achieve flexible suction on any angle and place

Multi-directional and Multi-angle
The suction cup is made of high-quality sealing rubber, 15cm diameter, thickened design, a single suction cup can bear 60kg, three suction cups can bear 180kg, no need to worry about the camera equipment falling down.

60KG
When 3 suction cups are firmly sucked, PYRAMID system payload can reach 60kg.

4.8cm diameter rubber net mat baseplate with 3/8 screw, which is suitable for ball head, three-axis head, hydraulic head, panoramic head, camera head, etc.

Pyramid installation tips
When using PYRAMID, press the suction cup down gently to make the suction cup suck tightly, and then press the suction cup button until the red line of the button enters the suction cup, which means it's suctioned firmly.

Please make sure that the suction cup is attached to a relatively flat body or glass.

Please clean the place before the suction cup is adsorbed to ensure that there is no dust, etc. Also clean the suction cup itself.

In case the unclean car body make PYRAMID system suction system unstable, check the suction status of the on-board suction cup immediately after one shooting.

In extreme conditions, such as severe bumps on the road, high-speed driving, rapid start and emergency stop, it is recommended to purchase ProTapes Pro Gaffer Tape to ensure a stronger adsorption force between the suction cup and the car body(or glass) to deal with extreme situations.

Please tie up the device with our safety strap.

Don't mount 3 suction cup in one piece glass in case there are scratch on glass or bad quality glass.

Ensure everything is properly secured before shooting.


- Vibration Isolator -
Get rid of vibration when using a camera gimbal rig with this Vibration Isolator Damp Head from DigitalFoto. The wire-style aluminum mount with a top and bottom plate and mounts between your rig and mounting gear to eliminate additional vibration if the rig is mounted on a vehicle or in motion using the PYRAMID car mounting system.