Tilta Canon 5D/7D Series Kit B - Tilta Gray

This camera cage provides complete protective armor for the Canon 5D, 5D Mark II, 5D Mark III, 5D Mark IV, 7D, and 7D Mark II cameras. It provides several 1/4"-20 and 3/8"-16 mounting points as well as three cold shoe mounting points. The base of the cage also provides several mounting holes when attaching your camera to gimbals to more easily fine tune the balance of your setup.

A variety of different baseplates can be attached to the bottom of the cage, allowing for various rod mounting and optional power supply configurations.

The quick release top handle and various optional side handles can be attached to the cage to provide for different ways to comfortably operate your camera setup.

This kit of the Canon 5D/7D series cage includes: the base Canon 5D/7D series cage, quick release top handle, ARCA and Manfrotto quick release baseplates, and finally the Tiltaing Side Power Handle with Run/Stop Type III (F570 Battery) along with the compatible Panasonic S series R/S cable.

- Quick Release Top Handle -
This quick release top handle easily and securely attaches to the top of the half and full Tiltaing camera cages. It provides several 1/4"-20 and 3/8"-16 mounting points as well as one cold shoe mounting point on the front and one on the back of the handle.

- Tiltaing ARCA Quick Release Plate -
This Arca-Swiss compatible quick release plate attaches directly to the bottom of the Tiltaing camera cages to allow you to quickly and easily attach and detach from Arca-Swiss support systems.

- Tiltaing Manfrotto Quick Release Plate -
This Manfrotto-compatible quick release plate attaches directly to the bottom of the Tiltaing camera cages to allow you to quickly and easily attach and detach from Manfrotto support systems.

- Tiltaing Side Power Handle with Run/Stop Type III (F570 Battery) -
This side handle attaches to the Tiltaing camera cages for Sony a7/a9, Canon 5D, and Panasonic S1.

A battery port on the bottom of the handle allows you to use a Sony F570 battery to power the Nucleus Nano motor via the 8V Micro-USB power output. A 12V DC output is also integrated into the handle.

The handle also has a built-in R/S button to allow you to record run/stop your camera with a compatible R/S cable.

- Tiltaing Side Handle Run/Stop Cable -
These cables for the Tiltaing Side Power Handle with Run/Stop give you run/stop capabilities in camera systems that support it. Simply plug the 7-pin end of the cable into the Tiltaing Side Power Handle with Run/Stop and the other end into the R/S port of the camera.

Note that this cable was specifically designed for the Tiltaing Side Power Handles with Run/Stop so the R/S function only works with these handles.