Logan Graphics 60" Simplex Elite Mat Cutter

2020-07-15T08:22:42

Not as clean cuts

GIOVANNI F.

2017-02-24T11:14:14

Great price. An up-grade from what I had before.

WILLIAM D.

2017-02-17T11:19:25

I am very pleased with quality of Logan's mat cutter. It is the right tool at the right price for the work I want to do with it.

WARD R.

2013-06-17T21:00:00

This is a wonderful tool for the person wanting to mat and frame their work. It works great. Simple to use and straight forward instructions. The cuts come out perfect. The anti-creep pin is a great idea. I have used cutters without this feature, and the process is more complex. The only complaint I have is I had to add shims to the right angle guild to get a square cut on full size mat boards. For the price it is a great machine.

ROBERT T.

2013-03-19T21:00:00

I had a Logan 750 (no dash) prior to buying the 760-1. My initial impressions are: · I don't know if it is the plastic cutters or what but it is not as smooth running. · I have very limited space so I have to set up each time I want to cut and the 760-1 is less friendly in this regard. It is disappointing because I didn't have these impressions of the 750 right out of the box. Maybe it will get better with time but you know what they say about first impressions.

Rhinomopolis

2013-02-11T19:00:00

For semi pro use, this is a great mat cutter. I've cut around 50 mats so far and I get consistent results. You do have to be careful when cutting the window as it has a tendency to not cut fully through the mat board. Swap out the blade often to avoid having to make multiple passes. If you need to cut lots of mats, but can't or don't want to go for the professional cutters, this is a great option. Be aware: to prevent the baseboard from warping you must store the cutter flat. If you're short on table/shelf space this may not be a good option for you.

VALERIE W.

2013-01-21T19:00:00

I haven't used this a lot yet but I believe it does take a little practice to get just the perfect cuts. I found that the bevel cutter may slip just a little at the end of a cut to create a bit of a dip in the corner. I had to be very careful when I got to the corners to make sure this didn't happen. The straight cutter worked well but the paper cutter is so so. Didn't seem to want to cut evenly and I had to go back a forth several times to get the paper all cut. I have a pro paper cutter that works much better. Haven't used the glass cutter yet. Certainly it works far better than a basic hand cutter as it keeps the matt firmly in place, is much easier to measure accurate cuts and does have multiple uses.

Daisy