SunwayFoto PFL-XT2 Two-Piece Structure Custom L Bracket for Fujifilm X-T2 Camera

2018-04-13T08:36:19

Excellent fit and finish, comparable to the “ Really Expensive Stuff” just no storage for the hex key. Conforms perfectly to the baseplate of XT-2

PAUL R.

2018-02-19T13:57:08

The two-piece design allows you flexibility: if you don't need to mount to your head in portrait mode (or you have a ball head that handles this), simply leave it off, and get unfettered access to the connections behind the door. With the 2nd piece attached, the door opens completely, and gives you access to the connections. Beyond the flexibility, this bracket has excellent build quality, is both sturdy and lightweight, and you can't beat the price!

James M.

2018-02-16T10:32:01

This fist perfectly and keeps the camera still - so in my book it does what I need it to do.

Brian K.

2017-08-25T11:40:32

This L bracket is great. It is a third of the price of RRS and fits just as tight to the camera. The machining is well done and it fits the camera.

JASON P.

2017-08-02T22:22:29

Nicely packaged just like the other SunwayFoto; however, the notch on the L-plate section is too small to accommodate the ring that goes on camera strap lug, unlike the Kirk and RRS versions which have a larger gap. The unit that I received also was not at 90 deg when the screws were tightened 90 deg. . . .more like 88 deg.

Andrew T.

2017-07-21T18:47:11

Everything about this L-bracket is great, except for one failure: there is a strap holder built in the right side of the bottom plate, which makes a "sharp" ending and touches my right palm. Every time I hold the camera, it digs into my palm... This single failure makes it unusable for me.

YUNLU Z.

2017-07-01T07:37:54

Hay, it works and great price. Ability to detach/attach on side of L- bracket was a selling point for me. Works great.

Julie L.

2017-06-29T10:32:45

I ordered this with some hesitation. I have been a Really Right Stuff fan for years. All of my other camera L-plates, lens plates, clamps, tripod and monopod heads, etc, etc are RRS. But this time I needed to save some money, so I gave this a try. I haven't really put it to the test yet, but the fit and quality seem very, very good. So far, I am pleasantly surprised and very pleased with this purchase.

KATHRYN P.

2017-05-22T12:34:13

It is always mounted to the camera, it gives you a little more grip on the camera and works great on my RSS ball head. and does the job perfectly. Everything is available, the battery compartment the accessory area for the remote etc. works as it is supposed to. No complaints. I would recommend it.

Maureen J.

2017-05-16T21:02:00

Thus is a good alternative to other expensive brackets, I have used them all. This allows access to the doors. I dont need to tether a lot vertically so the cable issue does not bother me. It fits perfect, has a nice finish, cannot beat the price.

THOMAS M.

2017-03-23T10:15:26

I have been waiting several months for this Sunway bracket to be available from a USA based retailer. All edges and corners are very smooth and the fit to the camera is excellent. As good as the big name L brackets but for a lot less money. I like the fact that this a two piece unit. I leave the lower horizontal portion on my camera for protection and I now have something for my pinky finger to grip (for a better total camera grip). I have been using a Sunway L bracket on my Nikon D600 for several years and it has protected my camera on a couple of occasions. It has never once become loose and I have not tighten it for a couple of years.

Tom L.