





This item is no longer available.
Review Summary
Accidents happen where life happens. Protect your favorite Adorama products and purchase a protection plan to stay covered from accidental damage, mechanical or electrical failure, and more.
If we can’t fix it, we’ll replace it at no additional cost.
Protect your product from drops, spills, and more.
Enjoy your gear without fear. We have you covered!
When regular use of your product over time results in mechanical or electrical failure.
We will never charge you a deductible after the purchase of a plan.
Our claims process is simple & easy and our customer service team is happy to help.
Adorama Protect powered by Extend is available for purchase to customers in the United States. Not available for purchase Internationally or in U.S. Territories.
Browse our FAQ
The included cables are compatible with numerous cameras and special dedicated cables can be purchased to link almost every camera to the TriggerSmart system. The following cameras are compatible with the included UK-70 trigger cable, for other cameras a separate trigger cable must be purchased
CANON
EOS 30, EOS 33, EOS 50E, EOS 300, EOS 300V, EOS 300D, EOS 350D, EOS 3000,
EOS 50, EOS 500, EOS 55, EOS 500N, EOS 300X, EOS Kiss, EOS New Kiss, EOS
Kiss 7, EOS Kiss III, EOS 7, EOS 7s, EOS 400D, EOS Digital Rebel, EOS Digital
Rebel X, EOS Digital Rebel XSi, EOS KISS X2, EOS 450D, EOS Digital Rebel XTi,
Kiss Digital, Kiss Digital N, ELAN 7N, ELAN II, ELAN DATE, ELAN 7, ELAN 7NE,
ELAN 7N, ELAN IIE, Rebel 2000, Rebel G, Rebel T2, Rebel Ti, Rebel X, Rebel XS,
EOS 1000D, EOS 500D, Rebel T1i,
EOS 550D, Rebel T2i, G10, G11, G12, 60D, 600D, Rebel T3i, Kiss X5, 1100D,
Rebel T3
PENTAX
K100D, K110D, K10D, ist DS2, K200D, K20D K7, ist D, ist DS, ist, ist DL,
MZ-6, ZX-L, MZ-, ist, DL2, K5
SAMSUNG
GX-1L, GX-1S, GX-10, GX-20, NX10, NX100, NX5
CONTAX
645, N, N1, NX, N Digital
Selectable for 5 ms(1/200 sec) to 5 seconds
Short Delay: 1 ms (1/1000 sec.) to 100 ms (1/10 sec.) - Long Delay: 100ms (1/10 sec.) to 10 seconds
Modes: Manual, auto 1 shot, auto re-arm
Manual Activation
Flash, infra-red beam, sound
7.9" - 6.6' (20 - 201 cm). 8deg. or 2deg. with focal baffle
850nm
Range: 1 - 1500 lumens. Sensitivity: 10 lumens
Frequency Response: 50 - 5000 Hz
x3 open collector (x2 trigger, x1 focus). 50v DC max at 100milliamps
Sensor: 1/4-20 thread
3.2 - 6.7" (8.1 - 17 cm)
x4 AA batteries, high power type, non-rechargeable or AC to low voltage PSU 6-9V DC at 100 milliamps. UK22 AC power unit recommended.
40 milliamps. When IR TX module is connected: 80 milliamps.
32 - 95deg. F (0 - 35deg. C)
14 - 122deg. F ( -10 - 50deg. C)
10 Newtons
IP53
Controller: 7.5x5.5x2" / 19.05x13.97x5.08 cm
Sensors: 3x2x1" / 7.62x5.08x2.54 cm
Kit: 2.2 lbs / 9.97 kg Controller: 11.5 oz / 326.0 g
Sensors: 1.5 oz / 42.52 g
Tripods: 10 oz / 283.49 g
The TriggerSmart Kit is a three-way triggering system for photo and video capture. TriggerSmart offers a simple way to trigger your camera by using sensors that detect sound, an increase in light intensity and the interruption of an infra-red beam. Each detection method has its own uses and its own control settings on the TriggerSmart Control Unit. For example, if photographing fireworks or lightning, use the Light Intensity Sensor, connect it to the Control Unit and connect the Control Unit to your camera using the included cables. If needed, adjust the light sensitivity of the sensor on the Control Unit and when the lightning strikes or fireworks go off, the sensor detects the increase in light and fires your camera to shoot.
With sound, the set-up is similar. Connect the sound sensor to the Control Unit and the Control Unit to the camera, adjust the sensitivity if you want the camera to fire only at very loud sounds and when that sound is detected, the TriggerSmart will trigger your camera to shoot. Single shots or continuous shooting are both possible. When using the system to detect movement with the Infra-red beam it is necessary to use both sensors, one to send the IR beam and one to receive it. With the receiving sensor connected to the control unit and the control unit to your camera, as soon as something moves through the IR beam, the camera fires. Because the IR Receiver is housed in the same unit as the Light Intensity Sensor and the IR Transmitter is housed in the same unit as the Sound Sensor, in order to use all three detection systems together, separate sensors must be purchased.
The TriggerSmart Kit comes with the UK15 Control Unit, IR Receiver/Light Sensor Unit, IR Transmitter/Sound Sensor Unit, two mini tripods to place the sensors, two control cables, one trigger cable, the UK70 triggering cable and one 2deg. baffle.
The Control Unit controls and adjusts sensitivities of the sensors, can introduce delays in camera triggering and can choose between single or continuous shooting. The TriggerSmart Kit is an affordable device for amateur and professional photographers and is particularly suited to shooting wildlife and lightning and can be utilized for a multitude of creative, fun and security purposes. More so, additional sensors and accessories are available for the kit to increase operational scope and triggering capabilities.