Used Lectrosonics Digital Hybrid Wireless UHF Belt Pack Transmitter with Fixed Antenna, 537.600 - 614.375 Frequency, 50mW RF Power, 76.7MHz Bandwidth, 2 AA Batteries

SKU: AUWLELMBB1

Recommended Items

Overview
Compare
Learn
Specs
Protection

Reviews about this item

Review Summary

Lectrosonics LMB Specifications

  • Operating Frequencies

    537.600 - 614.375

  • Frequency Selection Steps

    Selectable; 100 kHz or 25 kHz

  • RF Power output

    50 mW

  • Pilot tone

    25 to 32 kHz; 5 kHz deviation (Digital Hybrid mode)

  • Frequency Stability

    +/- 0.002%

  • Deviation

    +/- 75 kHz max. (Digital Hybrid mode)

  • Spurious radiation

    60 dB below carrier

  • Equivalent input noise

    -120 dBV (A-weighted)

  • Input level

    Nominal 2 mV to 300 mV, before limiting
    Greater than 1V maximum, with limiting

  • Input impedance

    2 kOhms

  • Input limiter

    DSP controlled, dual envelope "soft" limiter with greater than 30 dB range

  • Gain control range

    44 dB; digital control

  • Modulation indicators

    Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation
    LCD bar graph

  • Frequency Response

    90 Hz to 20 kHz (+/-1dB)

  • Low frequency roll-off

    -12 dB/octave; 70 Hz

  • THD

    0.2% (typical)

  • Controls

    Top panel slide switch; programmable as power, mute, talkback or no (off) function
    Side panel membrane switches with LCD interface for power on/off and all setup and configuration controls

  • Audio Input Jack

    Switchcraft 5-pin locking (TA5F)

  • Antenna

    Galvanized steel, flexible wire

  • Battery

    Two AA; alkaline, lithium, NiMH rechargeable

  • Battery Life

    Alkaline: 4.5 hours
    Duracell Quantum: 7 hours
    Eneloop 2400 mAH NiMH: 8 hours

  • Dimensions

    3.2 x 2.4 x 0.8" / 81.28 x 60.96 x 20.32mm

  • Weight

    5oz / 141.74g (including lithium AA batteries and wire belt clip)

Related Articles & Videos

About Lectrosonics Digital Hybrid Wireless UHF Belt Pack Transmitter with Fixed Antenna, 537.600 - 614.375 Frequency, 50mW RF Power, 76.7MHz Bandwidth, 2 AA Batteries

Experience superior audio transmission with the Lectrosonics Digital Hybrid Wireless UHF Belt Pack Transmitter. This advanced device operates within a 537.600 - 614.375 frequency range and is equipped with a fixed antenna for consistent, high-quality signal transmission.

This versatile transmitter is designed for a variety of applications, from video production to theater, stage, and house of worship settings. It can be configured for simple "one touch" operation with a single power on/off switch on the top panel, or for full access to all operational parameters using the side panel membrane switches and LCD interface.

The transmitter offers selectable frequencies in 100 kHz or 25 kHz steps across a maximum tuning range of 76.7 MHz, providing a total of 3072 available frequencies across three standard frequency blocks. This wide tuning range ensures compatibility with various frequency allocations.

The device's servo bias input accepts both mic and line level signals, offering a wide range of gain adjustment in precise 1 dB steps. The top panel LED indicators and LCD bar graph allow for accurate gain adjustments, ensuring maximum signal-to-noise ratio and minimal distortion.

The Lectrosonics transmitter is designed with an aluminum extrusion housing and machined aluminum top and control panels, finished with an ultra-hard, black electroless nickel finish for durability. It is powered by two AA batteries, with a secure battery door and reliable electrical contacts for uninterrupted operation.

The device's Digital Hybrid Wireless technology combines 24-bit digital audio with an analog FM radio link, providing outstanding audio quality and extended operating range. This patented design digitally encodes the audio in the transmitter and decodes it in the receiver, overcoming channel noise and delivering compandor-free audio.

With its 50 mW RF power, compatibility modes for use with analog receivers, and integrated multi-function switch for mute or talkback modes, the Lectrosonics Digital Hybrid Wireless UHF Belt Pack Transmitter offers a comprehensive solution for your audio transmission needs.

Lectrosonics Digital Hybrid Wireless UHF Belt Pack Transmitter with Fixed Antenna, 537.600 - 614.375 Frequency, 50mW RF Power, 76.7MHz Bandwidth, 2 AA Batteries Features

  • High-quality Digital Hybrid Wireless UHF Belt Pack Transmitter for superior audio transmission
  • Operates within a 537.600 - 614.375 frequency range with a fixed antenna for consistent signal
  • Versatile device, ideal for applications ranging from video production to theater and house of worship settings
  • Offers selectable frequencies in 100 kHz or 25 kHz steps across a 76.7 MHz tuning range
  • Features servo bias input for mic and line level signals with precise gain adjustments
  • Durable design with aluminum extrusion housing and ultra-hard, black electroless nickel finish
  • Powered by two AA batteries for reliable, uninterrupted operation
  • Patented Digital Hybrid Wireless technology for outstanding audio quality and extended operating range

Key Features

  • High-quality Digital Hybrid Wireless UHF Belt Pack Transmitter for superior audio transmission
  • Operates within a 537.600 - 614.375 frequency range with a fixed antenna for consistent signal
  • Offers selectable frequencies in 100 kHz or 25 kHz steps across a 76.7 MHz tuning range
  • Features servo bias input for mic and line level signals with precise gain adjustments
  • Durable design with aluminum extrusion housing and ultra-hard, black electroless nickel finish
  • Powered by two AA batteries for reliable, uninterrupted operation