Overview
Compare
Specs
Protection
Q&A

Questions & Answers

Reviews about this item

Review Summary

Select a plan in the Add Protection section above and purchase with this product by clicking “Add to Cart”.

image-protection

TRUSTED PROTECTION PLANS, EXCEPTIONAL SERVICE.

Invest in Pre-Owned Gear & Peace of Mind!

Extend coverage on pre-owned products after the retailer warranty ends and protect photo & video gear from accidental damage with Adorama Protect.

Repair or Replacement

Repair or Replacement

If we can’t fix it, we’ll replace it at no additional cost.

Accidental Damage

Extended Protection

Coverage for pre-owned gear begins after the retailer warranty ends, plus accidental damage protection for photo/video gear that starts on day one.

Peace of Mind

Peace of Mind

Enjoy your gear without fear. We have you covered!

Failure Protection

Failure Protection

When regular use of your product over time results in mechanical or electrical failure.

Zero Deductible

Zero Deductible

We will never charge you a deductible after the purchase of a plan.

Customer-Focused Support

Customer-Focused Support

Our claims process is simple & easy and our customer service team is happy to help.

Adorama Protect powered by Extend is available for purchase to customers in the United States. Not available for International and U.S. territories purchases. Plans on pre-owned items do not cover pre-existing damages.

Lectrosonics Hma Specifications

  • Operating Frequencies

    Band A1: 470.100 - 537.575MHz

  • Frequency Selection Steps

    Selectable; 100 kHz or 25 kHz

  • RF Power Output

    Selectable at 50 or 100 mW

  • Pilot Tone

    25 to 32kHz frequency
    5kHz deviation (in the Digital Hybrid mode)

  • Frequency Stability

    +/-0.002%

  • Deviation

    +/-75kHz (max in Digital Hybrid mode)

  • Spurious Radiation

    60dB below carrier

  • Equivalent Input Noise

    -125 dBV (A-weighted)

  • Input level

    Nominal 2 mV to 300 mV, before limiting
    Greater than 1V maximum, with limiting

  • Input Impedance

    300Ohms

  • Input Limiter

    Dual envelope "soft" limiter; greater than 30dB range

  • Gain Control Range

    55dB; panel mounted membrane switches

  • Modulation Indicators

    Dual bicolor LEDs indicate modulation of -20, -10, 0 and +10 dB referenced to full modulation

  • Frequency Response

    35Hz to 20kHz (+/-1dB)

  • Low Frequency Roll-off

    Adjustable for -3dB at 30, 50, 70Hz)

  • THD

    0.2% (typ. 100Hz to 20kHz)

  • SNR at Receiver Output: No Limiting

    Off: 103.5dB
    Normal: 107.0dB
    Full: 108.5dB

  • SNR at Receiver Output: With Limiting

    Off: 108.0dB
    Normal: 115.0dB
    Full: 113.0dB

  • Input Dynamic Range

    125dB (with full Tx limiting)

  • Controls & Indicators

    Power/Phantom "ON-OFF"
    Phantom voltage selector
    Audio input gain
    LCD w/membrane switches
    LED audio level indicators

  • Audio Input Jack

    Standard 3-pin XLR (female)

  • Phantom Power

    5V at 18 mA max., 15V at 15 mA max. and 48 V at 4 mA max., plus "OFF"

  • USB Port

    Used for firmware updates

  • IR (infrared) port

    For quick setup by transferring settings from an IR enabled receiver

  • Antenna

    Housing and attached microphone form the antenna

  • Battery

    Two 1.5 Volt AA alkaline

  • Battery Life

    AA alkaline; No Phantom Power: 5h 0m
    AA alkaline; 48V Phantom Power: 3h 30m

  • Capsule Interface

    1.25" opening and 28 thread pitch
    Power available: 5V, 25 mA max
    Input impedance: 1000Ohms

  • Emission Designator

    180KF3E

  • Dimensions (L x Dia.)

    4.25 x 1.62 x 1.38" / 107.95 x 41.15 x 35.05mm

  • Weight

    7.5oz / 212.62g (with AA batteries)

About Lectrosonics HMa UHF Plug-On Wireless Transmitter, Frequency Band A1 (470.100-537.575MHz)

With its innovative design, the HMa UHF Plug-On Wireless Transmitter, Frequency Band A1 (470.100-537.575MHz) is a versatile and high-quality solution for all your audio and video transmission needs. This advanced transmitter is compatible with any microphone or line level source via a standard XLR connector, offering selectable phantom power at 5, 15, and 48 volts. It can also be switched off for use with dynamic microphones and line level signal sources.

This reliable transmitter boasts a wide tuning range of up to 76 MHz, with precise tuning steps in increments of 100 kHz or 25 kHz, allowing for up to 3072 frequencies. This extensive tuning range spans three standard 25.6 MHz Lectrosonics frequency bands, each featuring 256 different pilot tone frequencies for seamless compatibility with all Digital Hybrid Wireless receivers.

The HMa UHF Plug-On Wireless Transmitter also includes DSP compatibility modes, making it adaptable to work with legacy Lectrosonics analog wireless microphone receivers and IFB receivers, as well as some receivers from other manufacturers.

Powered by two AA batteries, this durable transmitter features a multi-color LED for clear status indication. A USB port is included for convenient firmware updates, while an IR (infrared) port simplifies setup with IR enabled receivers.

The input amplifier of this advanced transmitter employs an ultra-low noise op-amp for quiet operation. It is gain controlled with a wide-range dual envelope limiter, providing over 30 dB of headroom above full modulation. A 24-bit A-D converter digitizes the audio, filtering out supersonic noise above 21 kHz. The resulting signal is encoded with a proprietary algorithm to produce an analog data signal for RF transmission.

The antenna, formed between the machined aluminum housing of the transmitter and the attached microphone or cable, functions as a dipole radiator when attached to a hand-held microphone and somewhat like a ground plane antenna when connected with a cable or plugged directly into a mixer.

The HMa UHF Plug-On Wireless Transmitter is a testament to Lectrosonics' commitment to delivering innovative, high-quality audio equipment. Its Digital Hybrid Wireless design combines digital audio with an analog FM radio link to provide outstanding audio quality and the exemplary RF performance of the finest analog wireless systems.

The battery compartment door is hinged to the housing and remains attached to the transmitter when opened. It securely latches in place and applies pressure to the batteries when closed. The two AA batteries are connected in series through a conductive plate on the door.

Setup and adjustments are made with the control panel membrane switches and LCD. The transmitter can be powered up without the transmitter output enabled to allow frequency adjustments without causing interference to other wireless systems nearby. The switches can also be bypassed to prevent accidental changes. Dual color LEDs indicate audio input level and the power LED changes color under low battery conditions.

In summary, the HMa UHF Plug-On Wireless Transmitter, Frequency Band A1 (470.100-537.575MHz) is a reliable, advanced, and high-quality solution for all your wireless audio and video transmission needs.

Lectrosonics HMa UHF Plug-On Wireless Transmitter, Frequency Band A1 (470.100-537.575MHz) Features

  • Accepts microphone or line level signals
  • Selectable 5, 15, 48 volt phantom power
  • 76MHz tuning range in 100kHz or 25kHz steps for up to 3072 frequencies
  • Selectable 50/100mW output power
  • Adjustable low frequency roll-off
  • Powered by two AA batteries
  • USB port for firmware updates
  • IR (infrared) port for fast setup
  • Solid machined aluminum housing

What's in the box:

  • Lectrosonics HMa UHF Plug-On Wireless Transmitter
  • PHTRAN3 Leather Pouch
  • Item Note: Battery Corrosion Insiode But Works Fine