Used Ikan MS-PRO Beholder 3-Axis Gimbal Stabilizer with Encoders - for Mirrorless Cameras

MS-PRO

The Beholder MS-PRO is designed specifically for professional filmmakers looking for a single handheld stabilizer for a large range of small cameras weighing up to 1.9 lbs. The Beholder MS-PRO is lightweight, easy to use, and can be carried in your camera bag. In addition, the MS-PRO is versatile enough to be used with a GoPro or Smartphone.

360 Motors

The 3-Axis gimbal features three 360 degree rotating brushless motors that give you a limitless range of motion.

Designed for Mirrorless Cameras

With a payload of up to 1.9 lbs., the MS-PRO has the ability to stabilize a widerange of today's popular mirrorless cameras such as the Sony a6300, Sony a7SII, Panasonic GH5 and even cameras as small as a GoPro or smartphone.

Advanced Stabilization

Using a 32-bit controller with a 12-bit encoder, the MS-PRO uses an adaptive PID algorithm to produce a reliably efficient handheld stabilizer. This means that the gimbal will respond faster, balance easier, and have a greater battery life.

Lock Mode

Lock Mode In Lock Mode, the Yaw, Pitch, and Roll axis work together to keep the camera pointed in one direction. The camera's composition will stay the same no matter how you move the handle.

Point & Lock

Quickly lock your camera into any position by manually pointing and holding it in any direction. After a few seconds, the camera will lock and hold its position until it is reset back to default.

Auto Inversion

Switch to Inverted Mode at any time by simply flipping the handle over the camera. Inverted Mode can be operated in conjunction with any of the Lock and Follow Modes.

Multiple Follow Modes

The MS-PRO features 3 different follow modes. In Yaw-Axis Follow Mode, the MS-PRO will only follow your pan movements. In Pitch and Yaw-Axis Follow mode, the MS-PRO will follow your pan and tilt movements. Finally, the 3-Axis Follow Mode gives you full control allowing you to pan, tilt, and roll.

Lock Mode will allow the camera to hold a certain direction, and will not follow, pan, or tilt.

Pan-Follow Mode allows the gimbal to follow pan axis, and hold the tilt position.

Follow Mode allows the camera to follow both tilt and pan directions.

3-Axis Follow Mode has no restrictions as it allows the camera to follow pan, tilt, and roll.

OLED Status Display

A display screen located on the back of the handle conveniently provides you with information on the battery life and operating mode.

Easy to Use

With a newly designed quick-release baseplate system, the MS-PRO is easy to balance without the need of any tools.

Multiple Mounting Options

The MS-PRO handle comes with two 1/4-20 mounts that are perfect for mounting accessories such as a light, microphone, or monitor. A 3/8-16 thread located on the bottom allows you to securely mount the MS-PRO to a tripod, jib, or dual handle support system such as the Ikan DGH.