
Review Summary
Accidents happen. Protect your favorite Adorama products and purchase a protection plan to stay covered from accidental damage, mechanical or electrical failures, and more.
If we can’t fix it, we’ll replace it at no additional cost.
Protect your product from drops, spills, and more.
Enjoy your gear without fear. We have you covered!
When regular use of your product over time results in mechanical or electrical failure.
We will never charge you a deductible after the purchase of a plan.
Our claims process is simple & easy and our customer service team is happy to help.
Adorama Protect powered by Extend is available for purchase to customers in the United States. Not available for international or U.S. territories purchases. Plans on open box items do not cover pre-existing damage.
Adorama Protect plans are available for ABS clients. If you have any questions or require assistanse, please call 800-223-2500
Browse our FAQ
O: 74.7MHz
Front Panel Set/Increment/Decrement Buttons
FM +/-25 KHz deviation
58 dB (77 dB with E.D.R.)
+/-25 KHz
Balanced XLR-3F and unbalanced 1/4"
1/4" wave telescoping omnidirectional
Audio input level, monitor jack volume, E.D.R.
13-20 Vdc or 12 Vac; 115Vac 60 Hz at 300 mA plug-in wallpack power supply
Ch., Freq, Audio Meter, Input setup, RF level and E.D.R.
Normal 25K MuV/m at 3m
High 80K MuV/m at 3m
42dB
No
No
No
No
No
Built-In, Fixed Threshold
B5DM522
Approx. 300' / 91.44m
<3 dB Variation (100 Hz-10 KHz)
Greater than 60 dB at 1 mV input
1 Fixed Channel (Channel 031)
(Recessed) 3.5mm Mini Jack
Yes, 3.5mm Audio Output (This Jack Also Serves as the Charger Input)
5Mu V typical/1Mu V maximum (12 dB SINAD at 25 kHz Deviation)
More than 35 dB Down at +/- 200 kHz
More than 50 dB Down
Less than 2%
2-3 Volts, (2) AA Batteries
20 mA
2x AA batteries, Alkaline, NiMH or NICAD
30 hours Alkaline, 20 hours NiMH, 10 hours NICAD
Into 8 Ohms: 2.0V / 15mW 3.0V / 80mV
Into 32 Ohms: 2.0V / 10mW 3.0V / 50mW
(at 10% distortion)
Volume/On/Off Switch
Red LED On Indicator
Bottom of unit
Backlit On/Tuning Indicator
Belt or Pocket
Omnidirectional in earphone cord
Complies with Part 15
0 to 50 deg. C / 32 to 122 deg. F
Telethin Driver
32 Ohms
3' / 0.91m
1/8" Mini Plug
Foam
100 Hz - 10 kHz
Receiver: 4 x 2.75 x 1" / 101.60 x 69.85 x 25.40mm
Transmitter: 1.75 x 7.5 x 5.9" / 44.45 x 190.50 x 149.86mm
800549423663
ST-300 Transmitter
The ST-300 Base Transmitter features 17 user selectable frequencies digitally controlled from the front panel control buttons, a headphone jack with adjustable level for input signal monitoring and a backlit LCD display that shows Channel, Frequency and Audio Input Level. On the back of the unit is a balanced XLR-3F as well as an unbalanced 1/4" input. Front panel controls and LCD display allow the user to select mic, line and 70 volt input options, attenuate the input levels and change hi/low RF transmit power. A new feature called Enhanced Dynamic Range (E.D.R.) works with the SR-400 receiver to provide clearer, more dynamic audio.
SR 50 Single Channel Receiver
The SR-50 Single Channel Receiver provides clear reception and the simplicity of a fixed channel. This economical receiver operates on one of 17 fixed narrow-band frequencies in the 72-76 MHz band. Ergonomic raised volume control knob make level adjustments easily accessible by feel. Recessed headphone jack provides extra protection for earphone connections. Two AA batteries give up to 30 hours continuous battery life.
Operating Features
Volume OFF/ON Control
This thumbwheel control serves as both an off/on switch and as a volume control. The Receiver is turned off when the control is in the extreme counterclockwise position, when viewed from the rear and the volume is loudest when the control is in the extreme clockwise position as indicated on the volume control.
Headphone Jack
The headphone jack accepts a 0.140-inch (3.5 mm) diameter miniature mono or stereo phone plug. A variety of accessory units can be plugged into this jack for reception of the desired channel(s) being transmitted.
Belt Clip
The belt clip supplied is detachable by spreading the wire apart at the tops and removing one side of the clip from the case and then the other.