Ikan EC1 Beholder 3-Axis Gimbal and MPA70 5 Section Monopod Extension Kit

EC1-MPA70-KIT
Looking to expand your creativity? Combine the iKan Beholder EC1 with a strong, lightweight and portable quick adjust monopod. Take your 3-Axis gimbal to a whole new level.

• Over 360 Degree Movement from Each Axis (Pitch, Yaw, & Roll)
• Works with DSLR & Mirrorless Cameras between 2 and 4.5 lbs
• Equipped with 3-Axis Gyro Stabilized Brushless Motors
• Equipped with 32-Bit Controller & 12-Bit Encoder

Jib/Operator
Mounting a Beholder to an MPA70 monopod adds stability, control and develivers a natural feel when operating a 3-Axis gimbal. No jib? No problem. By extending the iKan Beholder out on the monopod, you can create jib-like shots in a matter of seconds with no extra gear or complicated setups.

Drone Style Shot
Shoot among the trees in a drone-like fashion by raising your iKan Beholder on the MPA70 monopod. Give your shots the look of a drone without the risk of flight and record usable audio without loud propeller noise.

Strength Meets Portability
Constructed out of aluminum and weighing only 1.59 lbs., the monopod is still light enough not to weigh you down.

Twist to Lock
The MPA70 expands through 5 different sections. Each one features a twist lock knob for quick height adjustments.

Flip & Mount
The base of the monopod contains a 1/4"-20 screw that can be flipped around and converted into 3/8"-16.

360deg. Motors
The 3-Axis gimbal features three 360 degree rotating brushless motors that give you a limitless range of motion.

Advanced Stabilization
Using a 32-bit controller with a 12-bit encoder, the EC1 uses an adaptive PID algorithm to produce a reliably efficient handheld stabilizer.

Multiple Follow Modes
The EC1 features 3 different follow modes. In Yaw-Axis Follow Mode, the EC1 will only follow your Pan movements. In Pitch and Yaw-Axis Follow mode, the EC1 will follow your Pan and Tilt Movements. Finally, the 3-Axis Follow Mode gives you full control allowing you to Pan, Tilt and Roll.

Lock Mode (Profile 1)
Lock Mode will allow the camera to hold a certain direction and will not follow, pan or tilt.

Pan-Follow Mode (Profile 2)
Pan-Follow Mode allows the gimbal to follow pan axis and hold the tilt position.

Follow Mode (Profile 3)
Follow Mode allows the camera to follow both tilt and pan directions.

3-Axis Follow Mode (Profile 4)
3-Axis Follow Mode has no restrictions as it allows the camera to follow pan, tilt and roll.

MPA70 5-Section Lightweight Aluminum Monopod
iKan brings the strength of a tripod to a compact, lightweight and portable quick adjust monopod with the best versatility in its class.

• 5 Sections with Twist Lock for fast adjustments
• Double-Sided camera screw with a 1/4"-20 and 3/8"-16 thread

Extraordinary Range
No other monopod in its class has the ability to collapse down to 18.8 in. & expand up to 70.8 in. while supporting a payload of up to 35 lbs.

Perfect Match
The MPA70 pairs perfectly with iKan Beholder gimbals such as the EC1 or MS-PRO to expand your cinematic creativity, Simulated drone shots, jib shots and comfortable low angle shots can now be achieved using the monopod.