
Picture does not represent the actual item
This item is no longer available.
Review Summary
2025-06-03T11:24:49
Excellent equipment
JOSEPH L.
2025-05-20T09:39:05
Great product. Easy to setup and good build.
MUSTAFA S.
2025-04-06T13:38:23
Optimal for the run & gun photographers
THELMA N.
2025-02-05T07:40:47
It's a good piece of equipment i'm a little concerned about the front screen and I'm not a real fan of the battery cover door. It comes off fairly easily. Trying to read. The instructions is a little on the confusing side but once I got onto a YouTube review of step-by-step on how to program it was relatively easy.
HENRY F.
2024-11-19T15:41:36
It works great and fulfills what I need.
JERRY M.
2024-10-18T07:59:14
Worked perfectly. A very minimal bump and it snapped right off the camera. Too flimsy for wedding work as bumps and dings are just part of the job.
David T.
2024-10-04T10:11:24
This is a real nice. It fires the strobes consistently without a problem. The button layout is a nice upgrade. I accidentally broke my first trigger when my camera fell off of the stand. I loved the trigger so much I replaced it the following day.
KENNETH E.
2024-09-25T08:09:34
An improvement over the previous two models I own. Easier to find and make adjustments to all my strobes.
MICHAEL G.
2024-08-15T19:20:49
Works great!!!
CLARISSA H.
2024-08-03T13:33:18
This review applies ONLY to the Fujifilm version of this trigger. My copy of the Flashpoint R2 Pro Mark II trigger was hard to slide on and take off of my Fujifilm cameras (X-T1 and X-T3). When the trigger was on the camera, the contact points on the trigger did not align with the contact points on the camera hot shoe, so the TTL and high-speed sync functions didn't work. It could, however, control flash power levels and it could fire the flashes. I had to return the unit. The solution (suggested by Shua at Adorama, thanks, Shua!) was to get the Flashpoint R2 Nano for Fujifilm, which works great!
Joe M.
2024-07-16T08:22:18
Works like a charm
KEITH S.
2024-06-02T09:59:40
Yes, this trigger will work with an R6 Mark2. Just make sure you are not using electronic shutter mode; it will not fire in this mode. Use electronic 1st curtain or mechanical mode.
MELVINA E.
2024-05-22T07:28:47
Works as it should. A bit of a learning curve.
Rich F.
2024-05-15T13:11:13
This trigger was great until it fell out of my hand when unpacking from a Pelican case. It tumbled no more than 8 inches to the concrete and the screen was a mass of horizontal lines. It still worked but was unreadable - could not decipher what channel it was on. Very disappointed that it failed to survive such a tiny drop
CHRIS K.
2024-05-11T06:26:22
Excellent trigger which is extremely feature-rich. Most triggers lack some piece of functionality, but this one combines everything from backlit buttons, over channel search, to converting a TTL measurement into a manual setting. I believe the only feature it is missing is a "single pin" mode. This trigger has many buttons which saves one from menu-diving and/or pressing multiple buttons to get to a function/control. It arranges the group buttons near the dial and OK button, which makes it super quick to operate. Works very well with Eneloop (or similar) rechargeables as well. Highly recommended.
Thomas K.
2024-04-22T21:11:00
I had used it a lot in my workshop for several years, until they came out with the new R2Nano. It was very reliable and easier to use than most triggers I've tried. Very good paired with any of the R2 strobes.
David R.
2024-03-14T09:43:13
Perfectly paired to all my flashes and easy to use right out of the box
JOSE M.
2024-03-13T06:45:50
Works as designed and well; but it broke while walking between spots. It seems to be a little too heavy and plastic gave way just above the base. I'd look at either the nano or the smaller model instead
Jeffrey P.
2024-01-25T03:50:10
I already had this controller for Pentax. Now, with the Olympus/Panasonic version, I can control my two Flashpoint strobes from both of my cameras. That gives me great flexibility.
James B.
2024-01-11T07:31:31
Product is amazing much better than my old pocket wizards that I loved!!!
ANDRE D.
2024-01-04T10:15:03
Fast Delivery, Great customer service. The product looks amazing!
Lisa R.
2023-12-05T17:36:42
I am very pleased with this transmitter. I works very well with my Fuji GFX 50S Mark 2 and my flashpoint strobes.
JOHN G.
2023-12-04T19:49:26
I purchased this controller with two Zoom Li-Ion X TTL speedlights for use with my Pentax K3. I had no experience with wireless flash and was able to get everything working in minutes. I like this so much I bought another for my Olympus body.
James B.
2023-11-14T07:40:05
Great little flash!
HIMAGHNA B.
2023-11-01T10:05:55
I love that each group has its own button. I put all my lights on a different group so that they have individual control and I love that I can get to the settings quick and easy. I would buy this trigger again.
Martin V.
2023-10-29T19:39:21
Works great, but is as weak as rice paper. Don't even come close to bumping this thing while on camera. I've gone through 2 of these because I barely bumped into a door while the camera and transmitter were in my hip, and they just disintegrate.
JACOB S.
2023-09-18T10:13:40
Love it! Just started plying with off camera flash photography and decided to try this transmitter along with a Flashpoint R2 Zoom Speedlight. Very pleased.
DAVID J.
2023-09-15T08:38:18
Best trigger for flashpoint imo
Ken B.
2023-09-12T08:33:28
Super easy to set up and sync to my two Flashpoint XPlor 600 Pro lights. I would totally recommend this product.
Stacey N.
2023-08-21T04:56:26
Easy to set up and use. It stays connected to all my flashpoint lights during my sessions.
Jennifer W.
Extend coverage on pre-owned products after the retailer warranty ends and protect photo & video gear from accidental damage with Adorama Protect.
If we can’t fix it, we’ll replace it at no additional cost.
Coverage for pre-owned gear begins after the retailer warranty ends, plus accidental damage protection for photo/video gear that starts on day one.
Enjoy your gear without fear. We have you covered!
When regular use of your product over time results in mechanical or electrical failure.
We will never charge you a deductible after the purchase of a plan.
Our claims process is simple & easy and our customer service team is happy to help.
Adorama Protect powered by Extend is available for purchase to customers in the United States. Not available for International and U.S. territories purchases. Plans on pre-owned items do not cover pre-existing damages.
Browse our FAQ
Synchronization Delay Setting - [ 0 = OFF ] [ 1-100 US delay setting ]
Synchronization Delay Setting - [ 0 = OFF ] [ 1-100 US delay setting ]
Zoom Setting - [ 0 = No changes ] [ AU = Changes with lens ] [ 20, 24, 28, 35, 50, 70, 80, 105, etc ]
PC Sync Socket - [ 0 = PC Sync connect with Camera ] [ 1 = PC Sync connects with Flash ]
Rear Curtain Sync - [ 0 = OFF ] [ 1 = ON, camera shutter speed must be between 30s - 1/30s ]
Enable 1/256 Power Level - [ 0 = OFF ] [ 1 = ON, 1/256 is displayed as 1/128- ]
Fujifilm
Cameras that have PC sync socket
R2 2.4GHz Wireless
MSK
2 AA Batteries
>100 Meters
32
5 *(limited)
Hot Shoe
Sync Cord
Test Button
Hotshoe
Flash Shoe
2.5mm Sync Port - Input & Output
2.8 x 2.0 x 1.8"
5.2 oz
Exceeds my expectations
By jeffrey p.
A reasonably priced device that works well. Can trigger flash over a long distance. Works well on my Canon DSLR and can do HSS (which I could not do with another company's trigger / receiver set) at a cost much less than the Canon OEM products. I am presently using with a 5Div and two Canon Speedlights but the beauty of this product is that I can place any brand device with a Canon compatible hotshoe on it and it just works. What is also nice is the ability to add any other R2 receivers t...
View full Review
seem reliable, and are useful for basic off-camera wireless radio control of one or more compatible flashes
By MICHAEL S.
Adorama has been offering its TTL-capable FlashPoint R2 transmitter/receiver set for Sony cameras with a multi-interface shoe at least since the beginning of 2017, but only the transmitter was available with a multi-interface shoe. Now the receiver is FINALLY available (9/20/17). The units are smaller than a pack of playing cards, and they seem far more robust than the inexpensive manual Yuonguo radio triggers I used for my Canon DSLR. They take two AA batteries, so they should hold up wel...
View full Review
Flashpoint R2 TTL Transmitter for Fujifilm
The Flashpoint R2-TF is the ultimate radio transmitter system for Fujifilm MSLR's that connects to all strobes with sync ports and communicates to the whole R2 family including Flashpoint Streaklight, ZoomLi-on and Zoom and Fujifilm speedlights using X-Series TTL protocol without missing a beat. The incredible range of these compact and lightweight units as well as their integrated functions and features make them the first choice of professional photographers. The proprietary TTL and HSS enabled 2.4GHz R2 Radio Remote System radio triggers transmits atop a Panasonic or Olympus body with the essential TTL pass-through and laser AF assist and works with the complete family of Flashpoint Speedlights, Monolights and Strobe lights with R2 TTL radio transceiver built right in.
All the R2 enabled family communicate seamlessly: the lithium powered Zoom Li-on Canon, Nikon, and Sony TTL speedlights, the Zoom AA alkaline energized speedlight, the fantastic Streaklight 360 Canon and Nikon TTL powerhouse, and the portable 600ws XPLOR600 monolights. Older Flashpoint flashes can be fired and controlled off camera while being attached to the R2 Radio Remote Receiver FPRRR2RF to grace remote link to earlier models.
To compliment the traditional group ratio style interface, the R2-TF provides a full proprietary GR Group style interface allowing up to 5 Groups to be individually set to either TTL, Manual, or Off. The battery powered units provide TTL, HSS (High Speed Sync) and even a HSS pre-sync timing adjustment for precision synchronization. PC cord sync input and output ports are provided for external device remote sync without automation. R2-RF receivers are compatible with Fujifilm speedlights.
Controlling the remote strobes on the transmitter is straightforward, with a large clear LCD panel interface aside 3 separate buttons relating to channel, groups and modes, while a thumb wheel provides fast scroll adjustment for the selected function. A simple switch located on the side of the transmitter allows the laser pattern Focus Assist Light to be switched on and off when needed. The receiver is simply set to the matching channel and you are on the way to remote TTL heaven.
NOTE: If you are having trouble with HSS, change the setting for custom Function 11 to either 1 or 2.